Plastic cam gear on John Deere 425.

[Rigid1]

1 hour ago, s pump said:

You have those for Snapper Pro 61" ? Imma bout ready for a new set. I clocked a rock pretty hard last week. It was painful.

More than likely, just need the actual model number to look up and cross over the OEM blade # to a Gator blade..

I'm sorry I don't know where the m# would be on a snapper zero turn.

[spin_dry]

Delayed response, but here’s what was left of the cam. 1/3 of the teeth were gone and the governor was obliterated. The motor cleaned up fine.  I was a little concerned about the steel arms on the governor. They just sort of floated to the bottom of the oil sump when the motor let go. My son in law should get another 1000-1500 hours out of this motor. 

[Rod]

Owned 

[01mxz800]

2 hours ago, spin_dry said:

Delayed response, but here’s what was left of the cam. 1/3 of the teeth were gone and the governor was obliterated. The motor cleaned up fine.  I was a little concerned about the steel arms on the governor. They just sort of floated to the bottom of the oil sump when the motor let go. My son in law should get another 1000-1500 hours out of this motor. 

steel gear replacement kit?

 

[spin_dry]

27 minutes ago, 01mxz800 said:

steel gear replacement kit?

 

Yes.