CFM Posted March 17, 2021 Share Posted March 17, 2021 Frigging thing broke when unbolting the tensioner arm/pulley assembly off from chsincase. It is pressed in from backside or pulled in from chain side. Looks just like very small lug nut stud for car/truck. Looks like I have to pull chaincase out or a bit to do this as it appears not enough room between brake rotor and chain case housing. Is their an easier way than pulling chsincase ? Like a bigger hole thru brake rotor i’m not seeing on quick inspection or is pulling chaincase haleay easy ? This sled has sat outside without cover and ravaged by chipmunks. Most things I’ve touched either breaks or leaves my fingers in pee/poop/ or pine needles. I was minutes from being done with this sled and it’s problems and it felt like throwing one more for old time sake. Lolol Quote Link to comment Share on other sites More sharing options...
CFM Posted March 17, 2021 Author Share Posted March 17, 2021 Sorry for bad typing. My finger tips and phone keyboard don’t work well together. Quote Link to comment Share on other sites More sharing options...
jdels Posted March 18, 2021 Share Posted March 18, 2021 If its the one that the shaft bolts to then yes it comes out the backside and you do need to unbolt the back half of the case. It's a splined carriage type bolt with an O ring. Been there. Minutes from done..... 1 Quote Link to comment Share on other sites More sharing options...
CFM Posted March 21, 2021 Author Share Posted March 21, 2021 Thanks. Yup, was able to finally see that on microfiche and finding pic of part. It’s like a mini lug nut stud. Lol. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.